Instructions for Scratch
Testing Gold, Platinum & Silver
Back
to Precious Metal Testing & Assaying
CAUTION
Use extreme care in handling gold and silver testing solutions, for they are,
corrosive acids. In case of skin contact, flush with large amounts of water.
Then treat affected area with sodium bicarbonate or baking soda. If swallowed,
contact a physician or hospital at once. In case of spills. treat with water and
then sodium bicarbonate or baking soda.
TESTING FOR GOLD
Scratch the piece to be tested over the surface of the black stone provided,
press well so as to leave a visible deposit, preferably a line of one to
one-half inches long. For the most accurate testing it is recommended that the
user becomes familiar with comparative testing using standard gold testing
needles. For highest sensitivity place a scratch line with a gold test needle
next to the scratch line of the metal you are testing. Compare the speed at
which the scratches dissolve. If the test scratch dissolves more quickly than
the needle scratch, it is a lower karat than the needle.
Transfer a drop of the 10K solution to the scratch made. If the solution
dissolves the scratch on the stone. it means the object is less than 10K gold or
not gold at all. If the, solution leaves the scratch intact, it means the object
being tested is 10K or greater than 10K.
The scratching and testing is repeated with the 14K solution. If the Solution
dissolves the scratch on the stone, it means the object is less than 14K gold
(if the scratch dissolves slowly and leaves rusty color particles, it is
probably 12k gold). If the solution leaves the scratch intact, it means the
object being tested is 14K or greater than 14K. (CAUTION: Many objects are
marked 14K, but were fabricated prior to 1982 when it was legal to mark items
14K, but in reality the gold was 13.5K. When testing 13.5K gold, the 14K
solution will not dissolve the scratch, but it will make it lose its brightness
and it will turn it into a yellow-rusty color).
The scratching and testing is repeated with the 18K solution and the 22K
solution (if available) until the karat of the object is determined. Remember
that when the solution being used dissolves the scratch slowly and leaves rusty
color particles it is probably two karats lower than the solution being used.
On items of heavy weight and volume such as chains, coins, etc, where plating
could hide the true metal, it is recommended that a deep notch in the test piece
be made and the testing be made with the metal inside the piece
TESTING FOR SILVER
Scratch the piece to be tested over the surface of the black stone provided,
press well so as to leave a LARGE AND THICK visible
deposit, preferably a line of one to one-half inches long.
Transfer a drop of the silver solution to the scratch made, The color
reaction of the solution with the metal scratch will be as follows: (Take into
consideration that the background of the test stone is black).
90%-100%= Creamy
color
77%-90% = Gray
color
65%-75% = Light
Green color
NOTE: With the silver solution,
it is possible to test directly on the piece being tested, however, the solution
will dull the polishing of the piece, and leave a mark where the acid was
placed.
TESTING FOR PLATINUM AND WHITE GOLD
Scratch the piece to be tested over the surface of the black stone provided,
press well so as to leave a LARGE AND THICK visible
deposit, preferably a line of one to one-half inches long.
Transfer a drop of the platinum test solution to the scratch made. (Take into
consideration that the background of the test stone is black). The
material on the stone is platinum, it should keep its white, bright color.
Platinum test liquid can also be used for 18k and 14K
white gold. In the case of 18K, the material on the
stone should start changing to a light bronze color in about 3 minutes.
For 14K white gold, the material on the stone should disappear in about 15
seconds.