 |
 |
|
 |
||
 |
||
|
|
 |
|
|
|
|
|
||
|
||
|
|
|
|
 |
 |
|
|
|
 |
Files Gateway Page
Back to 
Abrasives Gateway Page
Back to 
Bench Tools
Gateway
Back to Shor
Contents
Gateway
"Click the Pix" or click the title to go to the subject you want to view.
| File Finder | ||||
| Basic Application | Type of File Recommended | . | Basic Application | Type of File Recommended |
|---|---|---|---|---|
| Flat Surfaces | Hand | Flat Surfaces-Corners | Barrette | |
| Flat Surfaces-Slots | Pillar & Crochet | Keyways Dovetail Ways | Barrette | |
| Curved Surfaces-Corners-Holes | ½ Round or Crossing | Gear Teeth Deburring | Barrette | |
| Corner of Curved & Flat Surfaces | Crossing & Crochet | Rounded Inside Corners-Holes | Round | |
| Slots-Wedge Shaped Openings | Knife | Rounded Corners | Crochet & Pippin | |
| Corners-Slots | Slitting or Equalling | Holes-"V" Slots | Pippin | |
| Slots | Warding & Screwhead | Roughening Surfaces for Grips | Checkering | |
| Edges (Joints) | Joint | Corners-Holes-Edges | 3-Square & Square | |
| Scale of Cuts- The lower the number, the coarser the cut ( so "00" is very coarse and "4" is very fine). | |||||||||||
|
Teeth per Inch (Upcut) |
30 | 41 | 51 | 64 | 79 | 97 | 117 | 142 | 173 | 213 | 295 |
|---|---|---|---|---|---|---|---|---|---|---|---|
| 10" and over in length | 00 | 0 | 1 | 2 | 3 | 4 | . | 6 | . | . | . |
| 4" to 8" in length | . | 00 | 0 | 1 | 2 | 3 | 4 | . | 6 | . | . |
| 3" in length | . | . | 00 | 0 | 1 | 2 | 3 | 4 | . | 6 | 8 |
| Escapement | . | . | 00 | 0 | 1 | 2 | 3 | 4 | . | 6 | . |
| Needle file 4" to 7¾" | . | . | 0 | 0 | 2 | 3 | 4 | . | 6 | . | . |
| Regular Rifflers | . | . | . | 0 | . | 2 | 3 | 4 | 6 | . | . |
|
|
|
|
 |
|
|
The I. Shor Co. |
|
I. Shor Canada |
| Shor International Corporation | |
| Fine Tools, Equipment and
Innovative Products Since 1918 20 Parkway West, Mt. Vernon, N.Y. 10552 Phone (914) 667-1100 Fax (914) 667-0190 |
|
|
e-mail: |
|
